 | | Re: Help with converting voltage on circuit board
|
|
(...) Thanks Dustin, those will help. I am inclined to agree with Philippe Hurbaine on the regulator. It is also obvious that it can take AC from the full wave rectifier near the power port. In answer to Davids question about the 4v connector (using (...) (18 years ago, 8-Apr-06, to lugnet.robotics, lugnet.technic)
|
| |
| | Re: Help with converting voltage on circuit board
|
|
(...) The BDX34 transistor + toroidal inductor above + LM339 comparator probably compose a switching regulator efficiently converting 13V input power to 4.5V for the outputs. Philo (18 years ago, 8-Apr-06, to lugnet.robotics, lugnet.technic)
|
| |
| | Re: Help with converting voltage on circuit board
|
|
I've taken some more detailed pictures of the circuit and the reverse side. (URL) through the manual, connections 6 and 7 are for sensors and connections 0-5 are for output (4V as labled on the cover), but you only can turn the circuit on or off. (...) (18 years ago, 8-Apr-06, to lugnet.robotics, lugnet.technic)
|
| |
| | Re: Help with converting voltage on circuit board
|
|
(...) Hi Dustin, I am an EE. Before I give you some advice, I need a bit more information about 9750 (I have never seen one in person): - I see a power jack: I assume this powers the electronic circuit, not the loads, right? What voltage is applied (...) (18 years ago, 8-Apr-06, to lugnet.robotics, lugnet.technic)
|
| |
| | Re: Help with converting voltage on circuit board
|
|
(...) Wow - I remember those, we used them at school. Now why is it that Peeron do not have an entry for it under 9750? Those are also some big old capacitors, I would be inclined to check out their ESR (a rating of their health if you like) before (...) (18 years ago, 8-Apr-06, to lugnet.robotics, lugnet.technic)
|
