 | | Re: Scissor Lift in LEGO?
|
|
Some photos of what you've tried so far would help a great deal. I was wondering if it would be possible to see how cloesly you're matching up the worm gears to the rack gears, theoretically, it should be possible, but if you're using more than one (...) (19 years ago, 4-Mar-06, to lugnet.technic)
|
| |
| | Re: Scissor Lift in LEGO?
|
|
"Geoffrey Hyde" <g.hyde@bigpond.net.au> wrote in message news:IvKtn1.16vD@lugnet.com... (...) (URL) may give some ideas. I made a nut out of two 8 tooth gears and used a string of worm gears as a lead screw, but I cannot find the picture. The best (...) (19 years ago, 4-Mar-06, to lugnet.technic)
|
| |
| | Re: Scissor Lift in LEGO?
|
|
Those are some interesting milling machines there Bob. How do you think they'd look if built in the newer studless beams? Do you think there'd be any insurmountable rigidity problems building with studless beams? I noticed you had one long worm gear (...) (19 years ago, 4-Mar-06, to lugnet.technic)
|
| |
| | Re: Scissor Lift in LEGO?
|
|
"Geoffrey Hyde" <g.hyde@bigpond.net.au> wrote in message news:IvLB88.1D9t@lugnet.com... (...) Actually the gears cannot rotate as they are meshed with each other. This causes them not only to support the screw, but act as a nut creating linear (...) (19 years ago, 4-Mar-06, to lugnet.technic)
|
| |
| | Re: Scissor Lift in LEGO?
|
|
(...) I'm sure they would. Sorry I just haven't taken any yet. But this thread has given me some great ideas to try... (...) The worm gears are aligned carefully, and they seem to mesh fairly well, but I think ultimately rack gears and worm gears in (...) (19 years ago, 5-Mar-06, to lugnet.technic)
|
| |
| | Re: Scissor Lift in LEGO?
|
|
"Bill Ward" <bill@wards.net> wrote in message news:Ivo9xE.1oBF@lugnet.com... (...) They do not mesh. We need a rack like this ///.../// not |||...||| . Bob (19 years ago, 5-Mar-06, to lugnet.technic)
|
