To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.technicOpen lugnet.technic in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Technic / 14637
  Re: New technique: three position piston control
 
(...) <snip> (...) The center stop is not the same spot when expanding vs. contracting. I did not try it at different pressures. I just pumped a hand pump as fast as I could to make the sequencer go. I've not seen it overshoot the mid point. (...) (...) (19 years ago, 25-Sep-05, to lugnet.technic, lugnet.robotics)
 
  Re: New technique: three position piston control
 
(...) 6 legs and 3 leg groups is a great idea!! (...) I've think about overshooting the mid point and i don't know sure but i think it will overshoot the mid point whan you link them in serie isn't it?... and when you build it into a walking beast i (...) (19 years ago, 2-Oct-05, to lugnet.technic, lugnet.robotics, FTX)
 
  Re: New technique: three position piston control
 
(...) I tried to make a sequencer using two mid-stop piston configurations, and it didn't work out on paper (at least the cases I tried.) Hmmm...... I think that with a walker, you probably need to add one more switch to instrument full (...) (19 years ago, 2-Oct-05, to lugnet.technic, lugnet.robotics, FTX)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR