|
| | Re: Brickfest Pneumatic Master and new Pneumatic Gate Circuits
|
| (...) [MUCH SNIPPAGE] Mark, I did this simple repost to remove the remainder of this conversation from events.brickfest. I'll go home and study your feedback, build models and test them, and provide a writeup. Kev (...) (19 years ago, 22-Aug-05, to lugnet.technic)
| | | | Re: Brickfest Pneumatic Master and new Pneumatic Gate Circuits
|
| (...) Kevin, I think "differential output" is what I really meant, though I called it "no leak" because the supply never leaks, one output or the other is always pressurised and there is never a state where both outputs leak. There is also only one (...) (19 years ago, 22-Aug-05, to lugnet.technic, lugnet.events.brickfest)
| | | | steering
|
| When I built my crane chassis, I found out that using gears would make it springy (due to the weight of the chassis), and also veryu difficult from the point of steering. I did notice however, that when the steering axle is turned in the middle, (...) (19 years ago, 22-Aug-05, to lugnet.technic)
| | | | Re: Telehandler finally completed
|
| (...) Kev (19 years ago, 22-Aug-05, to lugnet.technic)
| | | | Re: Dual Hex small piston compressor (repost)
|
| (...) Hi Kevin, Thanks. I am sorry for the slow feed back. I normally can only check in every week or two as I have no internet at home. Currently, we are on vacation in Lacaster, PA on our way to Ocean City, MD. :) (...) It is my understanding that (...) (19 years ago, 22-Aug-05, to lugnet.technic, lugnet.robotics)
| |