Subject:
|
Re: Small Pneumatic Hex Radial Engine
|
Newsgroups:
|
lugnet.technic, lugnet.robotics
|
Date:
|
Tue, 17 May 2005 16:55:34 GMT
|
Viewed:
|
3838 times
|
| |
|
|
In lugnet.technic, Kevin L. Clague wrote:
> It has been a while since I posted any new MOCs, so it pleases me to share this
> with you.
>
> Well, after the success of my compact small piston radial pneumatic compressor,
> I decided to try my had at an engine.
>
> http://www.brickshelf.com/gallery/kclague/dual-hex-compressor/p9090172.jpg
>
> Given that pistons have two ports, and pumps only one, the compressor geometry
> would not work. With a slight modification to twist the pistons 90 degrees, and
> larger spacing between the tri-blade parts (my new favorite part), it fit
> together nicely.
>
> The six pistons are broken up into three pairs. A given pair drives one switch.
> I've found that two small pistons to one switch is a good ratio. The switch
> drives the next piston pair in sequence.
>
> The integral stud spacing between the tri-blades allows for better structural
> reenforcement without much cross bracing compared to the compressor. The
> compressor had 1.5 stud spacing between tri-blades, making it difficult to make
> as structurally strong.
>
> Here are the images:
>
> http://www.brickshelf.com/gallery/kclague/hex-radial-engine/p5140073.jpg
>
> http://www.brickshelf.com/gallery/kclague/hex-radial-engine/p5140074.jpg
>
> http://www.brickshelf.com/gallery/kclague/hex-radial-engine/p5140077.jpg
>
> http://www.brickshelf.com/gallery/kclague/hex-radial-engine/p5140078.jpg
>
> http://www.brickshelf.com/gallery/kclague/hex-radial-engine/p5140079.jpg
>
> Enjoy,
> Kevin
Great!
How does it preform? What is the RPM? (when connected to your compressor & when
pumped by hand)
What is the torque?
- David
|
|
Message is in Reply To:
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
