|
|
 | | Re: using PWM output to control Lego motors
|
| (...) The signals output by the RC receiver will drive servos or RC motor speed controllers. The signal consists of a pulse of 1-2ms width in an 18ms cycle. For a servo, 1ms corresponds to 45 degrees turn one way, 1.5ms to centre and 2ms to 45 (...) (20 years ago, 2-Feb-05, to lugnet.robotics, lugnet.technic)
| | | | | Helicopter
|
| Just a few words from a newbie annoucing his first MOC : a (yellow) Technic Helicopter. As I said on (URL) MOCpages>, I had left my Legos from ten years now, and thanks to my kids, who are now asking me to play LEGO back, I have retrieved old Lego (...) (20 years ago, 2-Feb-05, to lugnet.technic, lugnet.announce.moc, FTX) !!
| | | | | Re: using PWM output to control Lego motors
|
| (...) Thank you, this clarifies things for me quite a lot. I was thinking that PWM was PWM, but now I see the important difference -- one is a means of transmitting data, and the other is a means for controlling current (integrated over many (...) (20 years ago, 2-Feb-05, to lugnet.robotics, lugnet.technic)
| | | | | Re: using PWM output to control Lego motors
|
| PWM for servo pulse is on a three wire system (Pos, Neg, and data). The pulse is a series of different length square waves sent to the servo or ESC in a certain length of time. This pulse is then translated by the servo or ESC as a "position" it (...) (20 years ago, 2-Feb-05, to lugnet.robotics, lugnet.technic)
| | | | | Re: Volvo FH12 6x2/4 500 Globetrotter XL, Sweet Candy, Scale 1:13
|
| (...) SHHHHHH! Vineet! It's LEGO! Apparently lego can't be pluralised. Ye log maar dalenge! Legoswami Samarth (20 years ago, 2-Feb-05, to lugnet.modelteam, lugnet.technic, FTX)
|
|
