|
|
 | | Re: Rolling ball clock revisited
|
| (...) I love it! Very nicely done! It was interesting to read this bit off your website-- " The problem should have been very simple: each minute, start the elevator until a ball is detected by one sensor. Unfortunately, my first try over a several (...) (20 years ago, 7-Dec-04, to lugnet.technic, lugnet.robotics, FTX)
| | | | | Re: Rolling ball clock revisited
|
| i have been waiting to see if some one would put my LDraw files to go use. i see many good modifications too! i will have to go home and try some of these modifications to my clock. i especially like the fix to prevent 2 balls form lifting, the ball (...) (20 years ago, 7-Dec-04, to lugnet.technic, lugnet.robotics)
| | | | | Re: set 8074 question
|
| (...) What about the grey flex tubes? (20 years ago, 7-Dec-04, to lugnet.technic)
| | | | | Rolling ball clock revisited
|
| I finally rebuilt (URL) Bob Kojima's rolling ball clock> with RCX control (and other minor modifications) (URL) Description of these modifications, program, photos, videos are (URL) here> Special thanks to Bob for the time spent to LDraw his (...) (20 years ago, 7-Dec-04, to lugnet.announce.moc, lugnet.technic, lugnet.robotics, FTX)
| | | | | Re: set 8074 question
|
| (...) 2 x 5.6cm 1 x 7.2cm 4 x 8.8cm 1 x 10.4cm 2 x 15.2cm ROSCO (20 years ago, 7-Dec-04, to lugnet.technic)
|
|
