Subject:
|
Re: SSClagorpion
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Tue, 20 Apr 2004 18:19:10 GMT
|
Viewed:
|
9541 times
|
| |
|
|
In lugnet.technic, Kevin L. Clague wrote:
> In lugnet.technic, Steve Hassenplug wrote:
> > This sounds like we can NOT do the table edge detection stuff, using it's feet.
>
> Hmmm.... We would need to know two things to determine we'd hit the edge of the
> table.
>
> 1. The foot is down as far as it will go.
> 2. The down foot is not touching anything.
>
> We would need one of these sensor pairs for each front foot.
Right. That's listed somewhere in my prior ramblings. It should work fine with
2 inputs (one for each foot)
> When the foot is down and not touching anything, we wait for the foot start to
> rise, and flip the muxes to backwards. At the time the legs get to the top,
> they will go backwards, so I don't think we'll walk off the table. • ...
>
> Remember, 7 of the 8 legs will be down at the time we realize that we're at the
> edge. Given that pneumatics are slow, we should have plenty of time to slam it
> into reverse.
We may need to figure something out, here. I think it WILL be a problem.
At any given time, he will (could) have only four feet on the ground, right?
If I understand this correctly, when he puts his other four feet down, and
senses one foot is off the table, he must continue walking forward, raising four
feet from the table, and leaving him standing on three feet, including NO front
feet.
That makes me think we'll have to consider weight distribution, and how it will
balance on three feet.
Steve
|
|
Message has 1 Reply:
 | | Re: SSClagorpion
|
| (...) OK. You are going to put two touch sensors on one port? I thought you needed to know that the leg is fully extended, but not touching. How will you do that with one sensor port? (...) You are right, he needs to balance on the three feet that (...) (21 years ago, 20-Apr-04, to lugnet.technic)
|
Message is in Reply To:
| | Re: SSClagorpion
|
| (...) I think that you are right, that they are the same thing. (...) Hmmm.... We would need to know two things to determine we'd hit the edge of the table. 1. The foot is down as far as it will go. 2. The down foot is not touching anything. We (...) (21 years ago, 20-Apr-04, to lugnet.technic)
|
300 Messages in This Thread:
(Inline display suppressed due to large size. Click Dots below to view.)
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
