Subject:
|
Re: Pre-1990 friction pegs removal techniques?
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Fri, 4 Jul 2003 14:18:06 GMT
|
Viewed:
|
1407 times
|
| |
|
|
I simply use a 16L beam with cross axle/peg type pegs in the outermost holes.
You align with the target beam on the one peg and then press the two beams
together forcing the black peg out with the other cross axle peg. I've done
whole 8865's this way. You can apply huge forces safely and without injury to
your hand.
Steve
|
|
Message is in Reply To:
 | | Pre-1990 friction pegs removal techniques?
|
| As most of you know, the black friction pegs included in Technic sets issued before 1990 had a design that made them extremely hard to work with. I was wondering how the rest of you go about removing these things from other other pieces. The method (...) (21 years ago, 1-Jul-03, to lugnet.technic)
|
13 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
