 | | Re: The latest rage in pneumatic computing —Kevin L. Clague
|
| | | (...) Arrow heads showing which direction you expect the air to flow (not including release) would be helpful also. I've tried to figure it out, but I've not had a lot of luck. (...) (21 years ago, 22-Jun-03, to lugnet.technic, lugnet.robotics)
|
| | | |
| | | | | Re: The latest rage in pneumatic computing —Mark Tarrabain
|
| | | | (...) Okay... I've added arrowheads to each line showing air flow direction. The switches are set up so that the center port is the conventional inlet, and the top and bottom ports the outlets. I say conventional, because I don't always use it that (...) (21 years ago, 22-Jun-03, to lugnet.technic, lugnet.robotics)
|
| | | | |
| | | | | | Re: The latest rage in pneumatic computing —Kevin L. Clague
|
| | | | (...) I was concerned about your use of switches that is backwards from normal. I transitioned through all the possible values and it never lost system pressure. Great job! Now I have to study the design so I understand how you did it. There's are a (...) (21 years ago, 23-Jun-03, to lugnet.technic, lugnet.robotics)
|
| | | | |
| | | | | | Re: The latest rage in pneumatic computing —Mark Tarrabain
|
| | | | (...) You know, I can really empathize with you on the fact that it might be cryptic. You don't wanna know how long it took me to get the wiring on it just right so that I wouldn't be committing any pneumatic violations. I'll try and explain how I (...) (21 years ago, 23-Jun-03, to lugnet.technic, lugnet.robotics)
|
| | | | |
