To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.technicOpen lugnet.technic in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Technic / 10721
    Re: EGAD! (pneumatics) —Mark Tarrabain
   (...) I was thinking that one could just use an ADC to directly convert the analog voltage level to a digital number of however many bits you could resolve it to and then taking that binary number to address a demux and have the demux's outputs (...) (21 years ago, 16-Jun-03, to lugnet.technic, lugnet.robotics)
   
        Re: EGAD! (pneumatics) —Kevin L. Clague
   (...) When using LEGO's firmware and NQC the maximum number of power levels you have is 8 (plus off?), so the most you can identiy is 9. This of course presumes that current draw by your compressor's motors doesn't mess with the voltage going into (...) (21 years ago, 16-Jun-03, to lugnet.technic, lugnet.robotics)
   
        Re: EGAD! (pneumatics) —Mark Tarrabain
   (...) Yes, the switches would need to remember their last set state. Ideally, this would be done through the use of electric pneumatic switches which, when not receiving any power, simply stay in the last position they were set in. If this isn't (...) (21 years ago, 16-Jun-03, to lugnet.technic, lugnet.robotics)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR