 | | Re: Melting Point of ABS (Re: Strengthening Gears)
|
|
Thomas: Lego uses primarily Bayer Novodur (and apparently to some extent Bayer Lustran) for its bricks. The exact composition of the Novodur is of course, like the recipie for Coke, is top secret, but it is probably closest to Bayer Novodur P2M-V A (...) (23 years ago, 6-Mar-02, to lugnet.technic)
|
| |
| | How about this for a technic challenge?
|
|
Using bricks instead of balsa, of course 8?) Could you build a 100g LEGO bridge that can support 209kg?????? (URL) (23 years ago, 6-Mar-02, to lugnet.technic)
|
| |
| | RE: SNOT - What's the commotion about?
|
|
(...) SNOT techniques in non-Technic building are generally quite different from Technic construction because the goals are different. The goal in non-Technic design is to fill in gaps as well as possible while adding lots of detail, and while using (...) (23 years ago, 6-Mar-02, to lugnet.technic)
|
| |
| | Re: "One set" pulling challenge
|
|
(...) Well, look at it this way: for now, you hold the #1 spot in the 8466 category! TJ (23 years ago, 5-Mar-02, to lugnet.technic)
|
| |
| | "One set" pulling challenge
|
|
Well, I got the first version of my 8466 puller done, but it can only lift 200g 8?( Back to the drawing board... ROSCO (23 years ago, 5-Mar-02, to lugnet.technic)
|
| |
| | Re: Melting Point of ABS (Re: Strengthening Gears)
|
|
(...) My guess would be 109C may be more likely - I'd be surprised if they could mold it at 109F. I'm guessing my bad experience with the heater was well over 109F (they were quite close to it), and they didn't "flow" anywhere near enough that I'd (...) (23 years ago, 5-Mar-02, to lugnet.technic)
|
| |
| | Re: Melting Point of ABS (Re: Strengthening Gears)
|
|
(...) Not so prolonged exposure to gas heater! (URL) (23 years ago, 5-Mar-02, to lugnet.technic)
|
| |
| | Re: SNOT - What's the commotion about?
|
|
(...) Oh really? What about the plane you did for last year's town comp with the upside down windows? (sure nobody else could see it, but the SNOT was there). I'm sure it'll simple happen when the need arises (wait till you try to build more stuff (...) (23 years ago, 5-Mar-02, to lugnet.technic)
|
| |
| | Re: SNOT - What's the commotion about?
|
|
(...) It's not a big deal at all for Technic builders, who are very familiar with building on all aspects and directions. However, for Town and Train builders, this is a major departure from the way Trains have normally been done. Building on side (...) (23 years ago, 5-Mar-02, to lugnet.technic)
|
| |
| | Re: SNOT - What's the commotion about?
|
|
(...) Well in using a piece on its side, or upside down, one can achieve new geometry, new shapes, new orientations etc. I guess the possibilities are endless. Too bad I have little or no experience using SNOT-techniques. -Bryan (23 years ago, 5-Mar-02, to lugnet.technic)
|
