 | | Re: Melting Point of ABS (Re: Strengthening Gears)
|
|
(...) My guess would be 109C may be more likely - I'd be surprised if they could mold it at 109F. I'm guessing my bad experience with the heater was well over 109F (they were quite close to it), and they didn't "flow" anywhere near enough that I'd (...) (23 years ago, 5-Mar-02, to lugnet.technic)
|
| |
| | Re: Melting Point of ABS (Re: Strengthening Gears)
|
|
(...) Not so prolonged exposure to gas heater! (URL) (23 years ago, 5-Mar-02, to lugnet.technic)
|
| |
| | Re: SNOT - What's the commotion about?
|
|
(...) Oh really? What about the plane you did for last year's town comp with the upside down windows? (sure nobody else could see it, but the SNOT was there). I'm sure it'll simple happen when the need arises (wait till you try to build more stuff (...) (23 years ago, 5-Mar-02, to lugnet.technic)
|
| |
| | Re: SNOT - What's the commotion about?
|
|
(...) It's not a big deal at all for Technic builders, who are very familiar with building on all aspects and directions. However, for Town and Train builders, this is a major departure from the way Trains have normally been done. Building on side (...) (23 years ago, 5-Mar-02, to lugnet.technic)
|
| |
| | Re: SNOT - What's the commotion about?
|
|
(...) Well in using a piece on its side, or upside down, one can achieve new geometry, new shapes, new orientations etc. I guess the possibilities are endless. Too bad I have little or no experience using SNOT-techniques. -Bryan (23 years ago, 5-Mar-02, to lugnet.technic)
|
