 | | Re: Power Pullin' With My Tractor
|
|
It's not pretty. I've sheared teeth on racks when using them for Z-axis (up/down) stages that had a fair bit of weight on them. It broke the pinions too : ( To be fair though, it was bad design on my part to use a rack and pinion for that. I should (...) (23 years ago, 26-Jan-02, to lugnet.technic)
|
| |
| | compact designs
|
|
Hi everyone! I need a few hint'n'tips, I was hoping you could help me with. 1) How to gear down a 9V motor, on the smallest amount of space, which includes a wormscrew and the engine itself in the smallest possible way. 2) Extenders, which are (...) (23 years ago, 26-Jan-02, to lugnet.technic)
|
| |
| | Re: Gear and Axle Strength (was Re: Power Pullin' With My Tractor)
|
|
(...) Has anyone tried making an axle of 2x2 round bricks with bearings made from 1x4 arch bricks? I just played with it a little and it looks like the bearing would work ok. You could also make a bearing from macaroni bricks, but I think it would (...) (23 years ago, 26-Jan-02, to lugnet.trains, lugnet.technic)
|
| |
| | Gear and Axle Strength (was Re: Power Pullin' With My Tractor)
|
|
(...) That sounds like a very good solution. My solution to preventing axle shear has been to create multiple shear planes (like the hinges of the boom on my crawler crane). The problem is that it takes up a lot of room and there can be a lot of (...) (23 years ago, 25-Jan-02, to lugnet.trains, lugnet.technic)
|
| |
| | Got my set of 6 Va's from S@H today
|
|
Quite interesting, but isn't the brain-thingy supposed to stay in the back-pack and not fall out? Huw (23 years ago, 25-Jan-02, to lugnet.technic.bionicle)
|
