 | | gearbox pack 673F - any use for it?
|
|
The gearbox pack 673F is now on sale at half-price at S@H (URL) there a good use for it? I could use it as a motor, except I can't tell how it's powered (how many volts, nature of connection). If it only works connected to another RC motor, then it (...) (19 years ago, 19-Oct-05, to lugnet.technic)
|
| |
| | Re: Pictures of New technique: Cascaded Trinary Pneumatics (aka mid-stop)
|
|
(...) I'll start a schematic next week as this week is an unusual week at work. That should cover the pneumatic circuit. Basically, each stage gets a feed from the compressor, which goes to the middles of the two switches that drive the next stage (...) (19 years ago, 17-Oct-05, to lugnet.technic, lugnet.robotics)
|
| |
| | Re: High Failure Rate of New Type 9V Geared Motor
|
|
(...) I had the same problem with one of mine. Using them in a fast RC car might do this if it gets slammed into something. I will inform Nathanael Kuipers of the problem since he works at TLC and can tell the proper person. (19 years ago, 17-Oct-05, to lugnet.robotics, lugnet.technic)
|
| |
| | Re: Road Grader
|
|
(...) Hi Vineet! The model is 80% done and I have run out of yellow studs. Here is Saturday's link- (URL) may decide to make it with a black stripe down the side which would utilize the large supply of black studs I have. Since I never make (...) (19 years ago, 17-Oct-05, to lugnet.technic)
|
| |
| | Crane MOC made during boredom
|
|
Hey all, thought I'd share my little crane MOC. It's a custom base with two new 9v geared motors used to drive each track through the following gears: 24 tooth crown on motor 24 tooth 8 tooth 8 tooth 24 tooth 8 tooth 24 tooth 40 tooth driving treads (...) (19 years ago, 17-Oct-05, to lugnet.technic)
|
