|
|
 | | Re: 6293 rc receiver Auxiliary output possible?
|
| thanks for checking Mark! that is more help than i expected. too bad it's not going to work. guess i'm going to have to buy another receiver from bricklink if i really want the extra output. bob (...) Bob Kojima ko@fial.com Fial Incorporated Telecom (...) (20 years ago, 15-Apr-04, to lugnet.technic, lugnet.robotics)
| | | | | Re: SSClagorpion
|
| (...) Thinking about this more....... One of the reasons that makes this slow is the inherent piston friction which combined with pressure defines the rate of expansion and contraction. So the rate is not very negotiable. But using rate * time = (...) (20 years ago, 15-Apr-04, to lugnet.technic)
| | | | | Re: SSClagorpion
|
| (...) <snip> (...) Well, I know of situations where LEGO has asked some people to recreate their MOCs for them. You know you have arrived if that happens. (...) Kevin (20 years ago, 15-Apr-04, to lugnet.technic)
| | | | | Re: SSClagorpion
|
| (...) ... (...) With twice the pistons, the pressure is not as great, but the volume of air would be doubled, right? Using logic, not physics, I think once the pressure is built up (to 13 psi) the compressor may have to do less work to keep it (...) (20 years ago, 15-Apr-04, to lugnet.technic)
| | | | | Re: SSClagorpion
|
| (...) Mark Riley was nice enought to point out the errors in my math. The area of the piston care is pi * r^2 = 0.2 Four times that is 0.8. So the minimal pressure needed is 10 pounds / 0.8 square inches or, 12.5 pounds per square inch. Still well (...) (20 years ago, 15-Apr-04, to lugnet.technic)
|
|
