| | Re: Hammer Help
|
|
What problems are you having? (...) (22 years ago, 12-Dec-02, to lugnet.technic, lugnet.robotics)
|
|
| | Re: Lego® Technic Motor (43362) int ernals
|
|
(...) Notoriously difficult (...) I'd rather use a hacksaw on a technic angle or axle connector. (...) Probably not so easily. (...) I'd rather propose the following operation (totally theoretic, use at your own risk): Saw of the protruding axle and (...) (22 years ago, 12-Dec-02, to lugnet.technic)
|
|
| | Re: Lego® Technic Motor (43362) internals
|
|
(...) I think it should have been possible there as well (I have a disassembled 71427 that was broken). As for compatibility, if you put an axle 2 into the hole it should be pretty much equivalent, maybe not as strong mechanically. Another question (...) (22 years ago, 12-Dec-02, to lugnet.technic)
|
|
| | Re: Lego® Technic Motor (43362) internals
|
|
(...) It should be fairly easy to saw off the axle and glue a bush to the shortened axle, thus getting an axlehole instead of the protruding pin. The mainproblems would be to - Get the bound strong - Get the bush centered on the axle Perhpas some (...) (22 years ago, 12-Dec-02, to lugnet.technic)
|
|
| | Re: MOC: Marine Pedestal Crane
|
|
(...) Me likes it! (...) Can't really grasp it... (...) I did, very much so! Thanks TJ! Any chance of videos of the beast actually moving? (...) So you're implying it took less then five building sessions to get the crane done? :-) Best regards, (...) (22 years ago, 12-Dec-02, to lugnet.technic)
|