Subject:
|
Re: Vision Command can see IR!?
|
Newsgroups:
|
lugnet.robotics.vc
|
Date:
|
Mon, 16 Oct 2000 23:08:46 GMT
|
Viewed:
|
3159 times
|
| |
|
|
Yes, the camera can "see" the IR signals sent by the IR tower or RCX bricks.
If you look at the IR tower you'll notice that the signal flashes much lower
then the "window" in the mold. It would appear as though LEGO changed the
board around after the created the mold.
The VC documentation says that the 2.0 firmware is required on the brick and
other people have told me that it automatically installed the new firmware
for them. That was not the case for me and I had to manually update the
firmware myself.
Ryan
--
Reply to rjschave at home dot com
http://members.home.net/rjschave
http://www.brickbay.com/store.asp?u=RJSchave
"Carl Jagt" <cjagt@interhop.net> wrote in message
news:G2JEDL.8LF@lugnet.com...
> Greetings,
>
> FYI -- While playing with my new Vision Command, the robo-cam swung by • me
> while I had the Mindstorm's remote control in hand; and I observed a point • of
> blue light eminating from the remote's IR head. A few quick and very
> unscientific tests later, it appeared that the Vision Command camera can • see
> into the infrared spectrum -- can anyone else confirm this?
> (Also, prior to getting the VC cam up and running, the Win98 software
> wanted to install RCX v2.0 into my v.10 RCX brick -- that surprised me...)
>
> Cheers,
>
> Carl Jagt
|
|
Message is in Reply To:
 | | Vision Command can see IR!?
|
| Greetings, FYI -- While playing with my new Vision Command, the robo-cam swung by me while I had the Mindstorm's remote control in hand; and I observed a point of blue light eminating from the remote's IR head. A few quick and very unscientific (...) (24 years ago, 16-Oct-00, to lugnet.robotics.vc)
|
5 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
