 | | Spybot Hardware Hacking
|
|
Hi All, April's Circuit Cellar magazine has an article I wrote on one method of hacking the Spybot. I emulated the I2C EEPROM with a PIC. I then mapped the upper 128 bytes of the EEPROM variable space (locations 0x80 through 0xFF) for use as an I/O (...) (21 years ago, 25-Mar-04, to lugnet.robotics.spybotics)
|
| |
| | Re: RCX to Spy messages thru IR communications route
|
|
(...) Hi John, I think the low nibble of the first byte contains the Link ID of the Spybot. It is zero if the Spybot is not linked to a controller. 1 if it is linked to controller 1, 2 if controller 2, etc. This should be easy to double check with (...) (21 years ago, 25-Mar-04, to lugnet.robotics.spybotics)
|
| |
| | Re: RCX to Spy messages thru IR communications route
|
|
(...) Okay, after banging my head against this for WAY too long I think I have finally figured out (somewhat) a few things that were previously completely lost to my understanding. If you want an RCX (running RCX2 firmware) to simulate a Spybot Ping (...) (21 years ago, 24-Mar-04, to lugnet.robotics.spybotics)
|
| |
| | Re: RCX to Spy messages thru IR communications route
|
|
(...) very astute info. You folks, and you J.H. are 'right-on' once again! Yes it works, but SPY seems to react only to very specific code strings (message A: byte 0=0x92, byte1=0x23; message B: byte 0=0x92, byte1=0xab; ... etc.), and immediately (...) (21 years ago, 19-Mar-04, to lugnet.robotics.spybotics)
|
| |
| | Re: RCX to Spy messages thru IR communications route
|
|
(...) Mark Riley wrote a program quite a while ago that sends IR messages to a Spybot from an RCX ((URL) The receiver side of this (running on the Spybot) is implemented in his post in MindScript. I just posted a message a few minutes ago which (...) (21 years ago, 16-Mar-04, to lugnet.robotics.spybotics)
|
