Subject:
|
Re: Using 'containers' in Robolab
|
Newsgroups:
|
lugnet.robotics.rcx.robolab
|
Date:
|
Mon, 16 Apr 2001 01:06:52 GMT
|
Viewed:
|
4975 times
|
| |
|
|
Jerry,
In lugnet.robotics.rcx.robolab, Jerry Kalpin writes:
> I'm having a bad time with the use of containers. I have an angle-container
> and then a container-fork. I was careful to use a (blue) modifier for both
> of them, set the port number on the angle-container and the specified number
> to the container-fork.
>
> But that bit of circuitry never works. Also, I don't seem to get any
> reasonable number in the container. I check the value in the container
> using 'Interrogate RCX' and it never corresponds to the value displayed in
> the RCX for port 2 where it is connected.
What kinds of numbers to see on the display and what kinds of numbers do you
see in the container? Can you send me your program? or at least post an image
of it somewhere? :)
|
|
Message is in Reply To:
 | | Using 'containers' in Robolab
|
| I'm having a bad time with the use of containers. I have an angle-container and then a container-fork. I was careful to use a (blue) modifier for both of them, set the port number on the angle-container and the specified number to the (...) (24 years ago, 14-Apr-01, to lugnet.robotics.rcx.robolab)
|
4 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
