 | | Re: sub-vi begin vs end control
|
|
(...) In a LabVIEW program (vi) there is a front panel and a block diagram. The front panel is the user interface and contains both controls and indicators. When you place a control/indicator on the front panel a corresponding terminal is created on (...) (21 years ago, 17-Jan-05, to lugnet.robotics.rcx.robolab, lugnet.robotics.rcx)
|
| |
| | RE: sub-vi begin vs end control
|
|
Hi Tom, Just for my education purpose, I'd like to understand the difference between the "begin" & "end" control boxes at the "Front Panel" window. Although they look identical, they must be different since they failed to wire to the blocks next to (...) (21 years ago, 16-Jan-05, to lugnet.robotics.rcx.robolab, lugnet.robotics.rcx)
|
| |
| | Re: sub-vi begin vs end control
|
|
(...) It is a leftover from LabVIEW. When you create a sub.vi, LabVIEW reuses the name of whatever is wired to the control/indicator. This behavior makes perfect sense in LabVIEW but much less so in Robolab. FWIW, the names are little more than (...) (21 years ago, 16-Jan-05, to lugnet.robotics.rcx.robolab, lugnet.robotics.rcx)
|
| |
| | sub-vi begin vs end control
|
|
Hi, After a sub-vi is created, there are two controls created namely begin and end. Would someone explain why they are backwards? That means, it creates an "end" control linked to the beginning of the sub-vi, while the "begin" at the end. Thank in (...) (21 years ago, 16-Jan-05, to lugnet.robotics.rcx.robolab, lugnet.robotics.rcx)
|
| |
| | Re: sub programs
|
|
"Elizabeth Mabrey" <emabrey@storming-robots.com> wrote in message news:200501140706.j0...ing.com... (...) Both RCX 1.0 and 2.0 use the same firmware which supports 40 total subroutines. Subroutines are dedicated to the five program slots so that (...) (21 years ago, 14-Jan-05, to lugnet.robotics.rcx.robolab, lugnet.robotics.rcx)
|
