| |
Hi Ralph,
I'm able to use <, =, >, 0<, and 0=,
but 0> is not defined. Any idea why?
Thanks,
Jonathan
|
|
Message has 1 Reply:
 | | RE: Whither 0> ?
|
| (...) Yes, it's not in the hFORTH (ANSI) standard. You can always do SWAP 0< instead. The new release I'm working on does define 0> .... As a workaround, you can define 0> as above, and then remove the alias later. Cheers, Ralph Hempel - P.Eng (...) (25 years ago, 3-Jun-99, to lugnet.robotics.rcx.pbforth)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
