Subject:
|
IR communication PC <-> brick with NQC
|
Newsgroups:
|
lugnet.robotics.rcx.nqc
|
Date:
|
Thu, 18 May 2000 06:25:39 GMT
|
Viewed:
|
1831 times
|
| |
|
|
Hi there !
For an educational project here at university we want to control a brick (1.0)
based robot with ir based communiaction over serial connection. We want to
use the Win Hyperterminal to control the robot.
Has anybody here some information or some NQC - code to do so ?
There's also the problem that we don't know well which parameters (baudrate /
data flow control ...) to use for the IR tower.
So any help is appreciated ...
Thank Thomas
|
|
Message has 1 Reply:
 | | Re: IR communication PC <-> brick with NQC
|
| (...) The RCX uses a special packet protocol which involes a lot of binary (non-ASCII) bytes, so controlling it with Hyperterminal won't work very well. Your best bet is to either write your own code to send the packets of the serial port or just (...) (25 years ago, 20-May-00, to lugnet.robotics.rcx.nqc)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
