Subject:
|
MacNQC 4.05b, RCX 1.0 and OS X 10.4.6 can't program the brick
|
Newsgroups:
|
lugnet.robotics.rcx.nqc
|
Date:
|
Fri, 22 May 2009 04:20:49 GMT
|
Viewed:
|
27333 times
|
| |
|
|
Hello with a query from the past...
I used MacNQC for ages on other computers but I find now that I can't
write a program out to an RCX 1.0 brick using MacNQC 3.04 or 4.05b. I
can send the firmware with no problem but when I try to download a
program I get a "communications error" type of message every time. This
is with either the USB tower or a regular serial tower through a
USB/serial dongle. I'm using a 1.33GHz G4 running Tiger 10.4.6. Has
anyone else seen this and know what critical step that I'm missing?
I've posted to LUGNET, but it takes forever for a non-member's post to
show up there apparently, so I'm taking a stab at the robot crew at
large here. Any ideas?
thanks,
DLC
|
|
Message has 1 Reply:
2 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
