|
|
 | | Re: How to read the touch sensors on the Scout in NQC?
|
| (...) That is what I thought, but it will determine if the touch sensor is pressed. (...) Dunno, I'll try. Then again, if !=255 works... (...) If it were not for Perl I'd never write a line of code ^_^ (23 years ago, 17-Dec-01, to lugnet.robotics.rcx.nqc, lugnet.robotics.scout)
| | | | | Re: How to read the touch sensors on the Scout in NQC?
|
| This program turns on motor A and leaves it running until a touch sensor attached to input 1 is pressed, then it turns off the motor and plays a sound: task main() { On(OUT_A); until(SENSOR_1 == 1); Off(OUT_A); PlaySound(SOUND_UP); } Dave (...) (23 years ago, 16-Dec-01, to lugnet.robotics.rcx.nqc, lugnet.robotics.scout)
| | | | | Re: How to read the touch sensors on the Scout in NQC?
|
| Hi Chris, (...) this is a bit crazy, unless your sensor value is a bit pattern. (...) This is sensible, but are you sure it's ok to use equality and not inequalities like SensorValueRaw(1) < 240? (...) but it's equivalent, also in C, where & is (...) (23 years ago, 16-Dec-01, to lugnet.robotics.rcx.nqc, lugnet.robotics.scout)
| | | | | Re: How to read the touch sensors on the Scout in NQC?
|
| I've sort of solved my problem, but not in a way which really makes total sense. Both of the below fragments work as expectd: #1 if ((SensorValueRaw(1) & SensorValueRaw(0)) != 255) #2 if ((SensorValueRaw(1) != 255) || (SensorValueRaw(0) != 255)) (...) (23 years ago, 16-Dec-01, to lugnet.robotics.rcx.nqc, lugnet.robotics.scout)
| | | | | How to read the touch sensors on the Scout in NQC?
|
| All, I'm feeling pretty stupid right about now. I've read the NQC docs, looked in the newsgroups, books, etc, but I can't seem to figure out how to read the touch sensors on my Scout. I want to implement a bumper checking task but no matter how I (...) (23 years ago, 16-Dec-01, to lugnet.robotics.rcx.nqc, lugnet.robotics.scout)
|
|
