 | | Re: About SetSerialComm(SERIAL_COMM_DEFAULT);
|
|
My new question is how to receive this packet data sent by SendSerialData()? Zhengrong (...) (23 years ago, 7-Sep-01, to lugnet.robotics.rcx.nqc)
|
| |
| | About SetSerialComm(SERIAL_COMM_DEFAULT);
|
|
Hi, Dave In your NQC Guide, there is a text about this function "The default is to send data at 2400 baud using a 50% duty cycle on a 38kHz carrier.", how about other settings, for example, parity and stop bit, is it odd parity without stop bit? (...) (23 years ago, 7-Sep-01, to lugnet.robotics.rcx.nqc)
|
| |
| | monitoring touch sensor
|
|
Greetings I have recently been learning to program in NQC and have run into a problem. I would like to monitor a touch sensor (with a Scout) so that if the sensor is pressed once and held down a motor runs forward. If the touch sensor is pressed (...) (23 years ago, 31-Aug-01, to lugnet.robotics.rcx.nqc)
|
| |
| | NQC can send/receive starnard firmware message to/from legOS
|
|
Check this message (URL) (23 years ago, 29-Aug-01, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: Love the new Music capability with the new firmware!
|
|
(...) Use NQC for that. Wonderful 2.0 support. Dean -- Dean Husby LUGNET Member #320 TFM's LEGO Workshop - www.akasa.bc.ca/tfm The Vancouver LEGO Club - www.akasa.bc.ca/vlc/ (23 years ago, 27-Aug-01, to lugnet.robotics, lugnet.robotics.rcx.nqc)
|
