 | | Re: NQC problem...driving me insane!
|
|
(...) Well, actually, that code works fine (running MacNQC, a fairly recent version, with 2.0 firmware). One thing to check, code-wise, is to display SENSOR_1 on the LCD, and see what the numbers are (is it set to raw mode? Is the sensor bad (I've (...) (20 years ago, 4-Jul-04, to lugnet.robotics.rcx.nqc, lugnet.org.ca.rtltoronto)
|
| |
| | NQC problem...driving me insane!
|
|
Hey all, I know I must be doing something very simple wrong here - but I can't for the life of me figure it out. What I'm trying to do: Have a light sensor pointed at a surface. Pass that value off to a variable (the variable then contains the (...) (20 years ago, 4-Jul-04, to lugnet.robotics.rcx.nqc, lugnet.org.ca.rtltoronto)
|
| |
| | Re: Straight moving with only one rotation sensor
|
|
I tried to include the LDraw file but I had problems posting. (URL) (20 years ago, 12-Jun-04, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: Straight moving with only one rotation sensor
|
|
I tried to include the LDraw file but I had problems posting. (URL) (20 years ago, 12-Jun-04, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: Straight moving with only one rotation sensor
|
|
I did this in the past (since disassembled the bot) and found it to be quite reliable; except on slippery surfaces and carpet. :) The trick that I employed was to gear-up the rotation sensor. This causes the rotation sensor to detect even a slight (...) (20 years ago, 11-Jun-04, to lugnet.robotics.rcx.nqc)
|
