 | | Re: About SetSerialComm(SERIAL_COMM_DEFAULT);
|
|
hi Zhengrong, probably Dave answered your question, but I didn't see his answer in this newsgroup. I'v done some tests with different serial protocols and different baudrates, see (URL) it's of some use to you. (...) best regards, Stef Mientki (23 years ago, 7-Sep-01, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: About SetSerialComm(SERIAL_COMM_DEFAULT);
|
|
My new question is how to receive this packet data sent by SendSerialData()? Zhengrong (...) (23 years ago, 7-Sep-01, to lugnet.robotics.rcx.nqc)
|
| |
| | About SetSerialComm(SERIAL_COMM_DEFAULT);
|
|
Hi, Dave In your NQC Guide, there is a text about this function "The default is to send data at 2400 baud using a 50% duty cycle on a 38kHz carrier.", how about other settings, for example, parity and stop bit, is it odd parity without stop bit? (...) (23 years ago, 7-Sep-01, to lugnet.robotics.rcx.nqc)
|
| |
| | monitoring touch sensor
|
|
Greetings I have recently been learning to program in NQC and have run into a problem. I would like to monitor a touch sensor (with a Scout) so that if the sensor is pressed once and held down a motor runs forward. If the touch sensor is pressed (...) (23 years ago, 31-Aug-01, to lugnet.robotics.rcx.nqc)
|
| |
| | NQC can send/receive starnard firmware message to/from legOS
|
|
Check this message (URL) (23 years ago, 29-Aug-01, to lugnet.robotics.rcx.nqc)
|
