legOS : 3927


Robotics / RCX / legOS / 3927	3926 \| 3928

Subject:	Re: Can't upload new program after I have used LNP under brickos
Newsgroups:	lugnet.robotics.rcx.legos
Date:	Mon, 26 Sep 2005 13:03:11 GMT
Viewed:	7098 times

On Mon, September 26, 2005 3:32 am, Andy78 wrote: > Hello, > |I have the following problem: > |when I use lnp under brickos, the rcx does no longer respond to the legotower. > |This means that I can't delete the program nor overwrite it. > | > |Pershaps somebody can help. > | > |Thanks, > | > |Andy You had to turn on the lnp, with something like this: (I forget the exact commands) lr_startup(); lr_init(); lnp_init(); Make sure you turn it off: lr_shutdown(); Steve

Message has 1 Reply:

		Re: Can't upload new program after I have used LNP under brickos
(...) Well, thanks for the help, that didn't actually work. But I found it out, what was my fault. In my Program I changed the LNP Base adress of the robot. After that the robot did not react to the default adress 0. So, at the end of the program I (...) (19 years ago, 29-Sep-05, to lugnet.robotics.rcx.legos)

Message is in Reply To:

		Can't upload new program after I have used LNP under brickos
Hello, \|I have the following problem: \|when I use lnp under brickos, the rcx does no longer respond to the legotower. \|This means that I can't delete the program nor overwrite it. \| \|Pershaps somebody can help. \| \|Thanks, \| \|Andy (19 years ago, 26-Sep-05, to lugnet.robotics.rcx.legos)

3 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search