 | | Strange BrickOS Timing —Gunther Lemm
|
| | | Hello out there, maybe someone can explain to me why the current brickOS release seems to have msleep()-amnesia ;-) We've been testing the data transfer to our Lepomux device. For some strange reason we were still using kernel 0.2.6.07nmChg with a (...) (21 years ago, 2-Dec-03, to lugnet.robotics.rcx.legos)
|
| | | |
| | | | | Re: Strange BrickOS Timing —Guido Truffelli
|
| | | | | Hi Gunther, (...) have (...) I'm NOT really an expert in brickOS, but these are the sources of delay and msleep: void delay(unsigned ms) { unsigned i; while (ms-- > 0) for (i = 0; i < 600; i++) // not well calibrated. ; } //! delay execution (...) (21 years ago, 3-Dec-03, to lugnet.robotics.rcx.legos)
|
| | | | | |
| | | | | Re: Strange BrickOS Timing —Guido Truffelli
|
| | | | Hi Gunther, (...) have (...) After some investigation I found this page on YOUR site: (URL) YOU state: Using Lepomux requires a stable timing on the motor port because it is used as a serial data port. Since brickOS does a lot of stuff (...) (21 years ago, 3-Dec-03, to lugnet.robotics.rcx.legos)
|
| | | | |
| | | | | | Re: Strange BrickOS Timing —Dietmar Cordes
|
| | | | Hi Guido, (...) That patch referes to an older transfer-protocol. The one we are using now, does not need SUCH a stable timing. But the Output from BrickOS is a lot worse than it was in older versions. I thing Gunther can explain this better, but I (...) (21 years ago, 3-Dec-03, to lugnet.robotics.rcx.legos)
|
| | | | |
| | | | | | Re: Strange BrickOS Timing —Guido Truffelli
|
| | | | Hi Dietmar, (...) Of course :-) Ciao, Guido (21 years ago, 3-Dec-03, to lugnet.robotics.rcx.legos)
|
| | | | |
