|
|
 | | How do i make a program to run on brickos
|
| Hi everyone, previous problems behind me now as it all works and i am well chuffed, I now just want to start running programs on it, and was wondering where do you write your programs? can you do it in notepad? or do i need a specific text editor? I (...) (22 years ago, 27-Jan-03, to lugnet.robotics.rcx.legos)
| | | | | Re: legos.srec
|
| Hi everyone, I have ran configure and unfortunaly cannot remember what messages appeared, and at the minute i have uninstalled all of cygwin and brickos and i am reinstalling everthing at the mo to try and get things sorted. I was just wondering (...) (22 years ago, 27-Jan-03, to lugnet.robotics.rcx.legos)
| | | | | Re: legos.srec
|
| (...) There is absolutely no way your h8300-hitachi-hms-gcc is in the root directory. Did you run configure? What did it say? Probably best to remove your brickos dir, and unpack again from the tarball. Max. (22 years ago, 26-Jan-03, to lugnet.robotics.rcx.legos)
| | | | | legos.srec
|
| Hi everyone, the problem may begin before these few lines so i will show more of the lines that were previous to that error message. Here goes: make[2]: Leaving directory '/brickos-0.2.6.0.ne...l/dll-src' make[2]: entering directory (...) (22 years ago, 26-Jan-03, to lugnet.robotics.rcx.legos)
| | | | | LegOS.srec
|
| Hi everyone, I do not have legos.srec or brickos.srec, cos of make depend not working. So i used the command Max suggested and now i get the message below. This is the error message i get when i try to use the "make clean all" make[2]: *** (...) (22 years ago, 26-Jan-03, to lugnet.robotics.rcx.legos)
|
|
