Subject:
|
problems with legos on notebook
|
Newsgroups:
|
lugnet.robotics.rcx.legos
|
Date:
|
Wed, 15 Aug 2001 13:11:39 GMT
|
Viewed:
|
1736 times
|
| |
|
|
Hallo!
Has anybody experiences with legos on notebooks?
I want to use legos under linux on a notebook computer. I use a serial
pcmcia card from socket communications. The serial port is configured as
ttyS0 (irq 4 and io-adr. 0x03f8 are configured correct by pcmcia
manager).
The infrared tower is found by firmdl3 or dll, but it does not get a
connection to
the rcx.
(I have the same problems with nqc.)
The basic settings for this serial port seem to be o.k. under linux, I
can control an external modem with this port and connect to an isp.
Only with the legos tools (and nqc) it does not work. Perhaps there are
some special settings to do under linux with setserial for this port?
Thanks for advice and best regards.
Michael Wisse
Hochschule Harz
D-38855 Wernigerode
|
|
Message has 1 Reply:
 | | Re: problems with legos on notebook
|
| Michael, I may not be much help as I only use my laptop for downloading programs, not development, and my serial port is built-in. Is there any message when it fails to connect, or not? Does it fail immediately, or timeout after a wait? Do firmdl3 & (...) (23 years ago, 16-Aug-01, to lugnet.robotics.rcx.legos)
|
5 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
