|
|
 | | Re: Sensor Power
|
| (...) Take a look at the functions ds_power_on() & ds_power_off() as defined in the dsensor.c kernel file. When you've set the sensor to passive mode, you should be able to manipulate the sensor power bits using these functions[1] or just use the (...) (21 years ago, 6-Jan-04, to lugnet.robotics.rcx.legos)
| | | | | Re: Motor Display
|
| (...) This problem has been fixed in the most recent CVS source file (dmotor.c), but as far as I can tell it hasn't been part of an offical release yet: (URL) (21 years ago, 5-Jan-04, to lugnet.robotics.rcx.legos)
| | | | | Re: The BrickOS Task Manager
|
| tid_t -> thread ID pid_t -> process ID ? "nanobapt" <nanobapt@wanadoo.fr> wrote in message news:3FF95FD4.608020...adoo.fr... (...) (21 years ago, 5-Jan-04, to lugnet.robotics.rcx.legos)
| | | | | Sensor Power
|
| ok, I have a real question. I'm interested in sending messages between RCXs using only the sensor ports. I've tested and found by switching between active and passive, signals can be sent, however, when the port is set to active, it is not powered (...) (21 years ago, 5-Jan-04, to lugnet.robotics.rcx.legos)
| | | | | Motor Display
|
| For some silly reason, I was browsing through the BrickOS code and I noticed this: void motor_a_dir(MotorDirection dir) { dm_a.dir = dm_a_pattern[dir]; dlcd_hide(LCD_A_LEFT); dlcd_hide(LCD_A_RIGHT); if (dir == fwd || dir == brake) (...) (21 years ago, 5-Jan-04, to lugnet.robotics.rcx.legos)
|
|
