Subject:
|
Auto Shut Off
|
Newsgroups:
|
lugnet.robotics.rcx
|
Date:
|
Wed, 1 Nov 2000 19:52:10 GMT
|
Viewed:
|
1656 times
|
| |
|
|
Hi all,
How do I turn OFF the auto shut off function of the RCX? I'd like to write a
program which contains some long (1hr) delays.
Thanks for replies,
MTapsak
|
|
Message has 4 Replies:
 | | Re: Auto Shut Off
|
| (...) If you set the delay to zero, the RCX will not shut off. I don't remember if the RCX Code software can set such a delay, but I know for certain you can send an opcode to do it. There are many documented ways to send opcodes if you need to go (...) (24 years ago, 1-Nov-00, to lugnet.robotics.rcx)
| | | Re: Auto Shut Off
|
| (...) If you have NQC, just issue the following command: nqc -sleep 0 I'm not sure if there's any way to do this from RCX Code or Robolab. Dave (24 years ago, 1-Nov-00, to lugnet.robotics.rcx)
| | | Re: Auto Shut Off
|
| (...) If I remember well there is an option on the RCX Setup (Advanced) page that will allow you to modify (and also switch off) the auto off delay. Jan (24 years ago, 2-Nov-00, to lugnet.robotics.rcx)
| | | Re: Auto Shut Off
|
| (...) Ok, to set the time out with RCX code you must hit the Oroboros (the sideways 8) and it will never shut off. This can be found under "Getting Started" then the far Right option on the bottom. Hope that helps. Dean -- Coin-Op's For Sale!: (URL) (...) (24 years ago, 2-Nov-00, to lugnet.robotics.rcx)
|
5 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
