 | | Re: Help with 9738 LEGO Mindstorms Remote Control —Dave Baum
|
| | | I just got one myself and it seems to work fine. The A, B, and C buttons turn on the motors (in either direction) as long as they are held. You can even hold multiple buttons down to turn more than one motor at the same time. The Message buttons (1, (...) (25 years ago, 11-Jul-99, to lugnet.robotics.rcx)
|
| | | |
| | | | | Re: Help with 9738 LEGO Mindstorms Remote Control —Robert Munafo
|
| | | | | Dave's reply is right on the mark, but I also want to point out that if you have downloaded a non-MindStorms O.S. to the RCX (i.e. any firmware other than the standard LEGO MindStorms firmware) the remote might not work either. I haven't tried any (...) (25 years ago, 12-Jul-99, to lugnet.robotics.rcx)
|
| | | | | |
| | | | | | | Re: Help with 9738 LEGO Mindstorms Remote Control —Dave Baum
|
| | | | | | (...) Robolab uses the same firmware as Mindstorms RIS, so the remote should work fine. Same goes for NQC. (...) You can write programs in NQC (also in RCX Code or Robolab) that respond to IR Messages. These messages can be sent from another RCX, (...) (25 years ago, 13-Jul-99, to lugnet.robotics.rcx)
|
| | | | | | |
| | | | | Re: Help with 9738 LEGO Mindstorms Remote Control —Ben Fleskes
|
| | | | Thanks Dave. I hadn't downloaded the firmware yet. Originally, I was simply hoping to use the remote control and the rcx to drive my trains. So I didn't bother to install the software. Now I know. Again, Thank you. Ben In lugnet.robotics.rcx, Dave (...) (25 years ago, 16-Jul-99, to lugnet.robotics.rcx)
|
| | | | |
