Subject:
|
Re: WeDo +RCX?
|
Newsgroups:
|
lugnet.robotics.rcx
|
Date:
|
Sat, 11 Jul 2009 14:12:50 GMT
|
Viewed:
|
26729 times
|
| |
|
|
In lugnet.robotics.rcx, Kevin Karplus wrote:
> So far as I can see from the Scratch interface, there is control of
> one motor, but no sensors. (There are sensors via the ScratchBoard,
> but not through the WeDo interface.)
>
> I don't have the WeDo hardware, so have not investigated further.
>
> Kevin Karplus
I saw a "WeDo 2 Puppet" project on the Scratch website that specifically
mentions the use of the tilt senso so I suppose it must be possible to use
sensors as well.
"The scratch project uses the tilt sensor to decide when they spin"
Jetro
|
|
Message has 1 Reply:
 | | Re: WeDo +RCX?
|
| (...) You are correct---there is a tilt sensor and a distance sensor value available in the sensor value block. These get shown even if the motor blocks are not being shown, so I don't know why I missed them before. The values are 0 if no WeDo (...) (15 years ago, 11-Jul-09, to lugnet.robotics.rcx)
|
Message is in Reply To:
| | Re: WeDo +RCX?
|
| So far as I can see from the Scratch interface, there is control of one motor, but no sensors. (There are sensors via the ScratchBoard, but not through the WeDo interface.) I don't have the WeDo hardware, so have not investigated further. Kevin (...) (15 years ago, 10-Jul-09, to lugnet.robotics.rcx)
|
7 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
