RCX programmable brick : 228


Robotics / RCX / 228	227 \| 229

Subject:	Re: Communication with PC using NQC
Newsgroups:	lugnet.robotics.rcx, lugnet.robotics.rcx.nqc
Date:	Tue, 9 Nov 1999 07:43:30 GMT
Viewed:	2821 times

Dave Baum wrote: > Could you be more specific on "querying its state" and "high-level > commands"? Taking the example of the maze-walker, the PC software should be able to keep track of the position of the robot and direct it through the maze. > If you're willing to write custom C++ code, you can pretty > much do whatever you want on top of the rcxlib stuff from the NQC source > base. Yes, I looked at the code and it only needs a higher-level wrapper. > Does any of this answer your question? Yes, it does, thank you. /Vlad

Message has 1 Reply:

		Re: Communication with PC using NQC
(...) You might find the following helpful... (URL) again, you might not. jack j-perdue@tamu.edu (25 years ago, 9-Nov-99, to lugnet.robotics.rcx, lugnet.robotics.rcx.nqc)

Message is in Reply To:

		Re: Communication with PC using NQC
(...) Could you be more specific on "querying its state" and "high-level commands"? If you're willing to write custom C++ code, you can pretty much do whatever you want on top of the rcxlib stuff from the NQC source base. Its pretty easy to send (...) (25 years ago, 9-Nov-99, to lugnet.robotics.rcx, lugnet.robotics.rcx.nqc)

7 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search