 | | Re: Programming in Assembly —Aaron Goodman
| | | | Cool, thanks I was able to find the doc here: (URL) post about the motor seems helpful, so if I understand right the way to run motor A forward would be "mov 0x030003,r0h mov 0x80,r0h" and for the motor C the same except 0x06? How does the (...) (21 years ago, 17-Jul-03, to lugnet.robotics.rcx, lugnet.robotics.rcx.legos)
| | | | | | | | | | Re: Programming in Assembly —Mark Riley
| | | | | (...) mentioned previously) that describes the on chip I/O features of the H8 if you plan on doing any work with the sensors. (...) to (...) that (...) To turn on motor C forward you would do this: mov #0x02,r0h mov r0h,@0x80:8 The second (...) (21 years ago, 17-Jul-03, to lugnet.robotics.rcx, lugnet.robotics.rcx.legos)
| | | | | | | | | | | | Re: Programming in Assembly —Aaron Goodman
| | | | | Ok, the motor stuff makes sense, I got a little confused with the shift thing. I looked at the proggamming manual some more and it explaned the @ (Register inderect) but I don't see why it is needed, also in you example you specify the data as (...) (21 years ago, 18-Jul-03, to lugnet.robotics.rcx, lugnet.robotics.rcx.legos)
| | | | | | | | | | | | Re: Programming in Assembly —Mark Riley
| | | | | (...) (how the manual says to do data)? That's because I don't like to type more than is necessary! :-) Take this line for example: mov.b #0x02:8,r0h This line is doubly redundant. The destination operand is an 8-bit register so the other qualifiers (...) (21 years ago, 18-Jul-03, to lugnet.robotics.rcx, lugnet.robotics.rcx.legos)
| | | | | | |
