Subject:
|
Re: remote control and rcx
|
Newsgroups:
|
lugnet.robotics.rcx
|
Date:
|
Fri, 9 May 2003 15:43:40 GMT
|
Viewed:
|
3085 times
|
| |
|
|
> I also had an evening not too long ago where none of my RCXes would take a
> firmware download. I tried a couple different computers, different towers,
> fresh batteries, different room lighting, and nothing worked. The next time
> I tried to do it (a couple weeks later) everything worked just fine.
I had a similar experience. In fact, it happens to me fairly regularly. I believe
I've traced it to bad connections in the tower's serial cable. After I fiddle
with it the problem usually goes away.
|
|
Message has 1 Reply:
 | | Re: remote control and rcx
|
| Brian B. Alano's utterance expressed in news:HEMMAJ.1n01@lugnet.com: (...) I have tried fiddling with the wires, but it's the same thing. At about 75% through the firmware download, it stops :( (22 years ago, 9-May-03, to lugnet.robotics.rcx)
|
Message is in Reply To:
| | Re: remote control and rcx
|
| (...) The RCX will not respond to the remote until you succeed in downloading the firmware. The built-in romware does not listen to the remote. The remote can be used with many RCXes at once, since it is a one-way protocol with no response messages. (...) (22 years ago, 8-May-03, to lugnet.robotics.rcx)
|
11 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
