|
|
 | | ROM of RCX 2.0?
|
| Hi, has anybody taken a look at the ROM of the RCX 2.0? Are there any significant changes? I'm looking in particular for changes in addresses of routines or data areas that could lead to interoperability problems. Jürgen (24 years ago, 16-Aug-01, to lugnet.robotics.rcx)
| | | | | (MS)2 Expander Web Site Updated
|
| I've updated my website with some changes to the building instructions for the (MS)2 Expander that might make it easier to build. (URL) Husby LUGNET Member #320 TFM's LEGO Workshop - www.akasa.bc.ca/tfm The Vancouver LEGO Club - www.akasa.bc.ca/vlc/ (24 years ago, 13-Aug-01, to lugnet.robotics, lugnet.robotics.rcx)
| | | | | Re: As promised - Mecha using RCX with MacNQC - Draft 1.
|
| I think you're off to a good start! You mention some problems that I think can be overcome, others I'm not sure about... but I'll offer my two cents anyway... (...) a) what's your gear reduction ratio? I see a worm gear in there, which is about the (...) (24 years ago, 11-Aug-01, to lugnet.build.mecha, lugnet.loc.au, lugnet.robotics.rcx)
| | | | | Re: As promised - Mecha using RCX with MacNQC - Draft 1.
|
| (...) I like the design, but as with most RCX-based walkers, it looks, well, 'clunky'. I realize this can't be helped considering the nature of what it is you are working with. I, too, have been working on a walker of this nature and have met with (...) (24 years ago, 11-Aug-01, to lugnet.build.mecha, lugnet.loc.au, lugnet.robotics.rcx)
| | | | | As promised - Mecha using RCX with MacNQC - Draft 1.
|
| Hi, well some weeks ago I promised that I'd begin a project of developing a Mech incorporating the RCX unit, some motors and sensors. Here is my very first attempt at a minifig scale Mech: (URL) RCX is programmed using MacNQC and at this stage only (...) (24 years ago, 11-Aug-01, to lugnet.build.mecha, lugnet.loc.au, lugnet.robotics.rcx)
|
|
