 | | Re: lcd display on RCX 1.0
|
|
(...) If you load RCX2 firmware in a RCX1 brick (they are fully compatible*), you'll have acces to this function (and all other RCX2 specific possibilities) Philo *Except for some minor differences in IR hardware. (18 years ago, 25-Jun-07, to lugnet.robotics.rcx.nqc)
|
| |
| | lcd display on RCX 1.0
|
|
NQC: with RCX2, it has a function to display a user defined value. Is there a way to do it with RCX 1.0? How about just to display the current mail value with RCX1.0? Suggestion? Thanks in advance. --Elizabeth (18 years ago, 24-Jun-07, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: Shutdown/Off while program running crashes BrickOS
|
|
(...) Yes, that should be the latest version. (...) That is correct. You shouldn't need to do anything else. At one point, I made some changes to the firmware so the program could also access the run button. But, normally all that is handled in the (...) (18 years ago, 17-Jun-07, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Shutdown/Off while program running crashes BrickOS
|
|
(...) I'm using what appears to be called BrickOS 0.9.0. It was installed using John Hansen's simplified installation from his BricxCC sourceforge site. I was under the impression that on later versions of BrickOS, like what I am using, the firmware (...) (18 years ago, 17-Jun-07, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Shutdown/Off while program running crashes BrickOS
|
|
(...) Gus, It sounds like the code is testing for pressing the run button, but not pressing the power button. I would think testing for shutdown would be good enough, but who knows... :) What version of BrickOS are you using? I'd be glad to take a (...) (18 years ago, 17-Jun-07, to lugnet.robotics.rcx.legos)
|
