 | | Re: RCX low battery indicator problem
|
|
(...) I've tried the RCX2 firmware (firm0328.lgo). Same results: after downloading the firmware the RCX beeps (low battery signal) and is locked. In BrickOS when I read the battery sensor and write it's value on the display it says 620 (mV, Ithink) (...) (21 years ago, 5-Jan-04, to lugnet.robotics.rcx)
|
| |
| | Re: The BrickOS Task Manager
|
|
tid_t -> thread ID pid_t -> process ID ? "nanobapt" <nanobapt@wanadoo.fr> wrote in message news:3FF95FD4.608020...adoo.fr... (...) (21 years ago, 5-Jan-04, to lugnet.robotics.rcx.legos)
|
| |
| | Re: New Robolab user saying hello!
|
|
In lugnet.robotics.rcx.robolab, Paul Britton wrote: <snip> I am an electronics test development engineer for satellite payloads and (...) <snip> Paul, you must have seen my 'Satellite Tracker'. If not, go to (URL) and navigate to that project. (...) (21 years ago, 5-Jan-04, to lugnet.robotics.rcx.robolab)
|
| |
| | Sensor Power
|
|
ok, I have a real question. I'm interested in sending messages between RCXs using only the sensor ports. I've tested and found by switching between active and passive, signals can be sent, however, when the port is set to active, it is not powered (...) (21 years ago, 5-Jan-04, to lugnet.robotics.rcx.legos)
|
| |
| | Motor Display
|
|
For some silly reason, I was browsing through the BrickOS code and I noticed this: void motor_a_dir(MotorDirection dir) { dm_a.dir = dm_a_pattern[dir]; dlcd_hide(LCD_A_LEFT); dlcd_hide(LCD_A_RIGHT); if (dir == fwd || dir == brake) (...) (21 years ago, 5-Jan-04, to lugnet.robotics.rcx.legos)
|
