 | | Re: I'm passing the NQC torch...
|
|
A few hours after I was working with my brand new RIS kit, I knew the programming environment was too limited for my needs. Thanks God there was NQC out there, very young but already very solid, offering an entire new world of possibilities. Without (...) (21 years ago, 12-Nov-03, to lugnet.robotics.rcx.nqc)
|
| |
| | Motors on Sensor ports
|
|
I'm just curious if there's any harm in connecting motors to active sensor ports... I know you don't get very much voltage/speed/torque, but you do get interesting readings that can be used to detect when the motor stalls. This is potentially a very (...) (21 years ago, 12-Nov-03, to lugnet.robotics.rcx)
|
| |
| | Re: Help w/install _or_ It all went so well
|
|
(...) [...] (...) Well it looks like the gcc-version-problem I had. The gcc >=3.x do not allow multiline strins without "\" anymore, which are still uses in brickos. So my hint is to install a gcc 2.95 and everything should work fine... Note: This (...) (21 years ago, 12-Nov-03, to lugnet.robotics.rcx.legos)
|
| |
| | Help w/install _or_ It all went so well
|
|
_warning_ I'm new to BrickOS, so be patient. I've just attempted to install using the instructions at (URL) went fine until step 4 command './configure; make' which looked like this: ... $ ./configure; make Welcome to the brickOS Makefile (...) (21 years ago, 12-Nov-03, to lugnet.robotics.rcx.legos)
|
| |
| | Re: I'm passing the NQC torch...
|
|
Dear Dave, All I can Say is Thanks. But that says it all. JL (21 years ago, 11-Nov-03, to lugnet.robotics.rcx.nqc)
|
