 | | Re: Programming in Assembly
|
|
(...) (how the manual says to do data)? That's because I don't like to type more than is necessary! :-) Take this line for example: mov.b #0x02:8,r0h This line is doubly redundant. The destination operand is an 8-bit register so the other qualifiers (...) (21 years ago, 18-Jul-03, to lugnet.robotics.rcx, lugnet.robotics.rcx.legos)
|
| |
| | Re: Programming in Assembly
|
|
Ok, the motor stuff makes sense, I got a little confused with the shift thing. I looked at the proggamming manual some more and it explaned the @ (Register inderect) but I don't see why it is needed, also in you example you specify the data as (...) (21 years ago, 18-Jul-03, to lugnet.robotics.rcx, lugnet.robotics.rcx.legos)
|
| |
| | Re: Programming in Assembly
|
|
A direct link to the page with the documents is (URL) Jürgen Stuber <stuber@loria.fr> (URL) rot 13 "fr" "se" (21 years ago, 17-Jul-03, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Programming in Assembly
|
|
(...) You should look at Kekoa Proudfoots documentation of RCX internals ((URL) and his librcx library to understand the calling convention for the ROM. Then get yourself the H8300 tools (gcc et al) somewhere, this includes assembler and (...) (21 years ago, 16-Jul-03, to lugnet.robotics.rcx, lugnet.robotics.rcx.legos)
|
| |
| | Re: Programming in Assembly
|
|
(...) mentioned previously) that describes the on chip I/O features of the H8 if you plan on doing any work with the sensors. (...) to (...) that (...) To turn on motor C forward you would do this: mov #0x02,r0h mov r0h,@0x80:8 The second (...) (21 years ago, 17-Jul-03, to lugnet.robotics.rcx, lugnet.robotics.rcx.legos)
|
