Subject:
|
Two NXT Back2Back
|
Newsgroups:
|
lugnet.robotics.nxt
|
Date:
|
Sun, 5 Aug 2007 19:49:20 GMT
|
Viewed:
|
21357 times
|
| |
|
|
Hello Community,
can direct connection of two NXTs (port4) with normal Lego-cables damage any
parts or drivers ?
Normally I use a special cable (Pins 3,5,6) to use the RS485 communication to
another NXT, but some guys told me, they have used the standard cable for tests.
Good idea or not ?
Bye
Christian
p.s.: pbLua works fine with bitrates from 9k6 to 921k
|
|
Message has 1 Reply:
 | | Re: Two NXT Back2Back
|
| (...) I do not see how you could burn any parts or drivers. Even if both ports would be in active sensor mode and (obviously) out-of sync, the electronics that connects the port to ADC should handle that as normally the same pin is used to power up (...) (17 years ago, 7-Aug-07, to lugnet.robotics.nxt)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in NXT programmable brick
|
|
|
|
|
|
