 | | RE: NXT external storage
|
|
(...) Yes. RobotC already supports an optional "fast" mode that is five times faster transmission when reading a single byte. For reading multiple bytes from an I2C device, RobotC is about 15 times faster than the NXT-G firmware. There are a couple (...) (17 years ago, 9-Apr-07, to lugnet.robotics.nxt)
|
| |
| | Re: Using NXT Port 4 EIA-485
|
|
(...) Do you think it is possible to read/write binary and ascii data to this device or is there a special protocol neccessary ? What about bitrate of EIA-485 device ? Is it possible to adjust bitrate to anything more usable (9600, 38400, 115200) ? (...) (17 years ago, 9-Apr-07, to lugnet.robotics.nxt)
|
| |
| | Re: NXT external storage
|
|
(...) Yes, 9600 bits/s is really slow for storage access. Is there a known way to increase the clock and transferrate of I2C ? Christian (17 years ago, 9-Apr-07, to lugnet.robotics.nxt)
|
| |
| | Re: EggArt - a 4-colour Easter egg painting robot
|
|
(...) The promised videos (1-2Mb each): (URL) at 11Mb: (URL) David Schilling (17 years ago, 9-Apr-07, to lugnet.robotics.nxt)
|
| |
| | Re: Using NXT Port 4 EIA-485
|
|
(...) What is not supported about this port in the standard NXT firmware? You can read from it and write to it using the IOMapRead and IOMapWrite syscall functions. Looking at the firmware source code it certainly looks like everything is setup to (...) (17 years ago, 9-Apr-07, to lugnet.robotics.nxt)
|
