NXT programmable brick : 454


Robotics / NXT / 454	453 \| 455

Subject:	Re: HELP! NXT brick flash now read-only!!
Newsgroups:	lugnet.robotics, lugnet.robotics.nxt
Date:	Sun, 4 Feb 2007 13:21:51 GMT
Viewed:	6074 times

> Since I was already in the SAM-BA software, I figured, heck, why not load > 1.04 on with it right now? So I did. And it seems that it loaded on > successfully. The brick booted, and I verified that it was now running > 1.04. Mission accomplished! > > ...except, what's this? I can't delete any files (such as the Demo Nathan, What software did you use to load V1.04? It sounds like there is something in there that set the firmware to read-only after it loaded it. Can you find any settings like that in that software? Steve

Message has 1 Reply:

		Re: HELP! NXT brick flash now read-only!!
(...) The Atmel SAM-BA downloader, included in their In-system Programmer package: (URL) was using an older version than the one currently available on their site, though (1.7 vs. 1.8). (...) Well, it would be nice to be able to get back IN to the (...) (18 years ago, 4-Feb-07, to lugnet.robotics, lugnet.robotics.nxt)

Message is in Reply To:

		HELP! NXT brick flash now read-only!!
All, Up until this point, I kept hearing that it was pretty much next to impossible to "brick" a brick. However, I think I've managed to be the first person to prove that it can be done (not that I'm proud of this fact :-( ). A few weeks back, I (...) (18 years ago, 4-Feb-07, to lugnet.robotics, lugnet.robotics.nxt)

8 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search