|
|
 | | Re: Two NXT Back2Back
|
| (...) I do not see how you could burn any parts or drivers. Even if both ports would be in active sensor mode and (obviously) out-of sync, the electronics that connects the port to ADC should handle that as normally the same pin is used to power up (...) (19 years ago, 7-Aug-07, to lugnet.robotics.nxt)
| | | | | Re: NXT memory map
|
| (...) I found everything here (URL) not directly at Atmel... Christian (19 years ago, 7-Aug-07, to lugnet.robotics.nxt.nxthacking)
| | | | | Re: RotateMotorEx hangs
|
| (...) The change I have made is to replace this: // Waits till angle reached index __rotate_firstPort0, __rotate_ports0, NA __rotate_Running0: getout __rotate_rs0, __rotate_firstPort0, RunState brcmp EQ, __rotate_Running0, __rotate_rs0, (...) (19 years ago, 6-Aug-07, to lugnet.robotics.nxt)
| | | | | RE: NRLink reading RCX response w/ RobotC
|
| (...) Look at the file "RCX2 LASM Byte Codes" for a description of each of the available opcodes. Read (URL) coupled with the contents of my previous email. (...) No valid message starts with with 'opcode' byte of '00' or 'FF'. [Check out the above (...) (19 years ago, 3-Aug-07, to lugnet.robotics.nxt)
| | | | | NXT memory map
|
| Hi, where can I get some more informations about NXT memory map when system is running ? 1. Startaddress of RAM (Range: 0x0000 0000 - 0x0000 FFFF) ??? 2. Startaddress of Flash (Range: 0x0001 0000 - 0x0003 FFFF) ??? Is it true, that the flashmemory (...) (19 years ago, 6-Aug-07, to lugnet.robotics.nxt.nxthacking)
|
|
