| | Re: EggArt - a 4-colour Easter egg painting robot
|
|
(...) Wonderful. This is not the typical Mindstorms Printer, of course ^_^ Congratulations David! (17 years ago, 10-Apr-07, to lugnet.robotics.nxt)
|
|
| | Re: Using NXT Port 4 EIA-485
|
|
(...) Hi, halfduplex is not the problem when connecting the NXT to an external MCU. My problem is the bitrate of 921,6 kbits/s. Simple cheap MCU like ATMega didn't support this bitrate (as far as I know). To add an external devices (e.g MCU+SD-Card (...) (17 years ago, 9-Apr-07, to lugnet.robotics.nxt, lugnet.robotics.nxt.nxthacking)
|
|
| | Re: Using NXT Port 4 EIA-485
|
|
(...) Hi John. I must have misunderstood something I was told a while back which went along the lines of "there isn't enough time to implement support for this feature". Perhaps there was some time after all ;) Do you know how large the OutBuf and (...) (17 years ago, 9-Apr-07, to lugnet.robotics.nxt)
|
|
| | Re: EggArt - a 4-colour Easter egg painting robot
|
|
(...) Congratulations on getting your egg painting robot done! Looks like you got your pen mechanism working exactly as you planned. Very nice! (...) What do you mean; I think the eggs are beautiful! But I think you should write "Happy Easter" on (...) (17 years ago, 9-Apr-07, to lugnet.robotics.nxt)
|
|
| | RE: NXT external storage
|
|
(...) Yes. RobotC already supports an optional "fast" mode that is five times faster transmission when reading a single byte. For reading multiple bytes from an I2C device, RobotC is about 15 times faster than the NXT-G firmware. There are a couple (...) (17 years ago, 9-Apr-07, to lugnet.robotics.nxt)
|