|
|
 | | compilation switch in BrickCC Command Center?
|
| Thru brickcc command center, I wonder how to insert a user-defined compilation switch as I want to use it in the preprocessor directives. Input is greatly appreciated. --Elizabeth (18 years ago, 6-Feb-07, to lugnet.robotics.nxt, lugnet.robotics)
| | | | | Re: HELP! NXT brick flash now read-only!!
|
| (...) Juergen et al., Good news, everyone! The nightmare is over. :-) And I got to learn a few things in the process, too! Setting the security bit must have been what I did, although I don't specifically recall it...I do remember that, before I (...) (18 years ago, 5-Feb-07, to lugnet.robotics, lugnet.robotics.nxt)
| | | | | RE: HELP! NXT brick flash now read-only!!
|
| (...) It may be obvious, but: Holding the reset pin for a few seconds simply does a brick reset. Holding the reset pin for around 15 seconds is supposed to put the brick into SAMBA mode. You are doing the second I hope. And just to be safe, you've (...) (18 years ago, 4-Feb-07, to lugnet.robotics, lugnet.robotics.nxt)
| | | | | Re: HELP! NXT brick flash now read-only!!
|
| (...) OK, everybody take a deep breath and slow down. first of all, the SAMBA version I'm using is 1.11, available here: (URL) And for anyone that's going to get busy hacking firmware, this is a great place to start: (URL) Yes, there is a script (...) (18 years ago, 4-Feb-07, to lugnet.robotics, lugnet.robotics.nxt)
| | | | | Re: HELP! NXT brick flash now read-only!!
|
| (...) The Atmel SAM-BA downloader, included in their In-system Programmer package: (URL) was using an older version than the one currently available on their site, though (1.7 vs. 1.8). (...) Well, it would be nice to be able to get back IN to the (...) (18 years ago, 4-Feb-07, to lugnet.robotics, lugnet.robotics.nxt)
|
|
